All of the Hein-Werner Engine Stands and Lifts, are “Made in USA”. The Floor Jacks and Jack Stands are manufactured or assembled in the US with US and Global components, built to the highest standards of quality and performance in the automotive industry. Hein-Werner is affiliated with Shinn Fu Company of America, Inc., a division of the global Shinn Fu Corporation based in Taiwan, Republic of China.
The Pin style Jack Stands are labeled “Made in USA” they support in 7 Ton, 10 Ton, and 25 Ton loads per pair. The maximum support height for the High Reach Jack Stand is 52 inches.
The 3 Ton and 6 Ton Rachet Style Jack Stands are assembled in the US with US and Global components.
The two and three ton Floor Jack is listed under the Products | Hein-Werner | Jacks | Service Jack tab; they are assembled in the US with US and Global components.
The Engine Stands are listed under the Shop Equipment tab. Both the 1250 lbs and 3 Ton Engine Stand is labeled as Made in USA.
The Lifts or Air Jacks: 2-1/2 Ton, 10 Ton End Lifts and the 10 Ton Wheel Lift is labeled Made in USA.
Visit the website listed below and mouse to the Products tab then Hein-Werner pop out tabs for more information.
Shop Local: Where to Buy
Contact via:NetMail
Jack Stands, Floor Jack, Engine Stands, Lifts
Kansas City, Missouri 64153Map
There is not much “assembly” to put together a ratchet style jack stand. I would be very careful of “assembled here” claims.
I have seen where people thought that a tool was completely made in the USA just because it has an American flag decal on it. Be very careful and ask questions.